Products

Filter Ag

Filter Ag

is highly fractured edges and irregular surfaces provide a high surface area and complex flow path for efficient removal of suspended matter throughout the filter bed, typically reducing suspended solids down to the 20-40 micron range. Filter-Ag’s larger particle size creates less pressure loss, allows deeper particle penetration into the bed for greater sediment loading, and extended filter run cycles. Filter-Ag relatively lightweight allows for lower backwash flow rates and better bed expansion to release trapped sediment during backwash. Filter-Ag can be used in both pressure and gravity flow systems. It can also be used as a layer in multi-media filter designs allowing a more flexible approach to difficult filtration problems.

Specifications

ColorLight grey to near white
Bulk density24-26 lbs./cu. ft
Specific gravity2.25 gm/cc
Mesh size12 x 30
Effective size 0.67 mm
Uniformity coefficient1.8
Hardness6 (Mohs scale)
Water pH rangeWide range
Maximum water temp.140°F/60°C
Bed depth24-36 inches
Freeboard50% of bed depth (min.)
Service flow rate5 gpm/sq. ft., Although considerably
higher rates are often used
Backwash flow rate8-10 gpm/sq. ft.
Backwash bed expansion 20-40% of bed depth
  • Upon installation allow bed to soak overnight before backwashing
  • Reduced shipping cost due to light Weight/cu. ft.
  • Replacement of sand with Filter Ag in existing installations may increase filter capacity 100% or more. (Caution should be taken upon start-up that the lightweight Filter-Ag is not washed to drain.)
Category:

Browse Our Services

Browse Top Innovations