This is a highly sensitive test for total chlorine including chloramines in feed water as well as for chlorine in rinse water after disinfection with chlorine containing disinfectants (for example Sporotal 100). DiaQuant® Chlorine allows the quick and easy determination of chlorine in water. The easy Dip & Read procedure provides reliable results within 10 seconds.

Rinse Water

Hemodialysis equipment may be disinfected using chlorine bleach especially after dialysis of high risk patients (for example Hepatitis patients). Using DiaQuant® Chlorine allows an easy check if the equipment is adequately rinsed

Feed Water

Water used to prepare dialysate is cleaned up using reversed osmosis systems. These require low chlorine levels to ensure longevity of the device and purity of the water. DiaQuant® Chlorine allows the easy detection of total chlorine including chloramines down to 0.1 mg/l (ppm).

This test strip is for the convenient and reliable determination of low-range water hardness in feed water. The easy Dip & Read procedure provides reliable results in 10 seconds. The test is used after the watersoftener stage of the clean-up process. Softening is a pretreatment for water that usually undergoes further purification processes like reversed osmosis. Hard water can damage the delicate osmosis units, thus decreasing its effectiveness and operating life. Water hardness is the total concentration of Calcium and Magnesium expressed in degree of water hardness or in mg/l (ppm). With DiaQuant® Water Hardness levels down to 0,3°d or 5 mg/l (ppm) can safely be detected ensuring proper feed water for the reversed osmosis system.

This test strip is designed to check the pH value of rinse water after hot disinfection with hydroxy acetic acid containing disinfectants (for example Diasteril). The test strip allows the quick and easy determination
whether disinfectant residues are present. The easy Dip & Read procedure provides dependable results in 5 seconds. Hemodialysis equipment is often cleaned using Hydroxy-acetic-acid containing reagents, that
need to be washed out prior to the next use. With this test, technicians can easily check if the system is sufficiently rinsed.

• Need very short time for activating and stopping
• Suitable for air, water, gas, vacuum, light fluid
•  Operating temperature range from -5°C to 90°C
• Maximum working pressure 17 kgf/cm2
• Coil protection IP65
• Explosion-proof coils meet T4, T5 and CE standard